State any two factors to consider when determining the method of timber conversion

Method of conversion

  1. Log size / diameter
  2. Type of wood
  3. Structured defects
  4. Timber use
  5. Type of sawing machine
  6. Proportion of heartwood to sapwood

Print Friendly, PDF & Email
Post Views: 4
Tell your friends about this content:

Related posts:

  1. What determines the size of a surface planer?
  2. Show by means of sketches two typical uses of a sliding bevel
  3. Name one man – made board made from Wood fibres
  4. Name one man – made board made from Wood particles
  5. Name the metal most commonly used for making a jack plane
  6. List – two advantages of a metal plane over a wooden plane
  7. Outline the process of boring a hole on wood using an expansive bit
  8. advantages and 2 disadvantages of using paint on wood surfaces
  9. The figures below shows an abrasive material
  10. Illustrate two methods in edge treatment on a block board
  11. The figure 2 below shows an exploded view of a joint used in woodwork. Sketch the views of the assembled joint in first – angle projection.
  12. The figure below shows an isometric block. Draw the following views ( full size) in first angle projection:
  13. Define the term timber conversion
  14. Make a cross – section through a tree trunk naming all the parts.
  15. Briefly explain the function of at least 4 parts of a tree trunk
Leave a Reply 0